Kalk dispenser

[limbo1001001]

Hi Roger,

I have had the Osmo and kalk dispenser for about a year, and I think the inline tube at the bottom is getting clogged with kalk.

When the Osmo turns on, the flow into the reactor doesn't look like it is stirring up the kalk like it used to.

Is there a preferred way to clear any kalk buildup from the inlet tube?


Thanks,
Jim

 

[rvitko]

I usually just replace the tubes, they tend to get hard and even if you could clean them it is best to just replace them every once in a while.

 

[limbo1001001]

Do the tubes just slip into the dispenser? They look like they are glued. If so, what type of glue should I use to attach the new tube?


Jim

 

[rvitko]

I thought you meant the hoses, I take it you mean the rigid connector pieces?

 

[limbo1001001]

I'm sorry Roger,....my bad. I "inherited" this dispenser, and when I got it, the hoses were already attached. I thought the hoses themselves were glued into the dispenser. I didn't want to try and pull the hoses for fear that I would break something.

I got the hose off and cleaned the hole out. Thanks for the enlightenment.


Jim