jungliztkruger
New member
This tank is about nine months old. It was a downsize from a 37 gallon to help facilitate a 10 hour move that is coming up in a few weeks. I'm going to try and post a few pics then the specs will follow. 
I still haven't mastered the art of uploading pictures but it will have to do.
Here are a few specs:
This is a typical off-the-shelf 10 gallon aquarium that I modded with an acrylic overflow chamber. When first set up the tank had a crushed coral substrate but now is bare-bottom. There is about 2-3 pounds of liverock in the system. I have the skimmer set up with the pump in the overflow and the return is directly to the right of it. It is an Aqua-C remora. Inside the overflow chamber have temp and ph probes, heater, dual float switches, kalk ato tube, and occasionally carbon in a media bag. It is a very busy section. I designed it so that all water that enters the chamber is processed through the skimmer before entering the aquarium again. The probes are hooked up to an aquacontroller. I am running 175 watt Mogul 14k MH in a Lumenbrite Mini. It is an SPS bulb on a Hamilton Ballast. For flow inside the tank I have an MP10 turned all the way up though it is on reefcrest mode. I top of with premixed Kalkwasser and go thorugh almost 2 gallons a week.
paramaters:
Salinity 35ppt
Temp around 81.7 F
PH 8.27
NO3 Undetectable
Ca 335 ppm
Mg 1170 ppm
Alk 11.6 Kh

I still haven't mastered the art of uploading pictures but it will have to do.
Here are a few specs:
This is a typical off-the-shelf 10 gallon aquarium that I modded with an acrylic overflow chamber. When first set up the tank had a crushed coral substrate but now is bare-bottom. There is about 2-3 pounds of liverock in the system. I have the skimmer set up with the pump in the overflow and the return is directly to the right of it. It is an Aqua-C remora. Inside the overflow chamber have temp and ph probes, heater, dual float switches, kalk ato tube, and occasionally carbon in a media bag. It is a very busy section. I designed it so that all water that enters the chamber is processed through the skimmer before entering the aquarium again. The probes are hooked up to an aquacontroller. I am running 175 watt Mogul 14k MH in a Lumenbrite Mini. It is an SPS bulb on a Hamilton Ballast. For flow inside the tank I have an MP10 turned all the way up though it is on reefcrest mode. I top of with premixed Kalkwasser and go thorugh almost 2 gallons a week.
paramaters:
Salinity 35ppt
Temp around 81.7 F
PH 8.27
NO3 Undetectable
Ca 335 ppm
Mg 1170 ppm
Alk 11.6 Kh
Attachments
Last edited: