Latest Version ? Display of Temperature ?

[StevieK]

Own Profilux 3 and have two questions

1. i have tried to update the firmware, however, i am unsure if i have succeeded. Where can you look to see what version you are running?

2. Having trouble getting the temperature to display on the device screen and through the web. The temperature is fine within the application.

thanks in advance

 

[AQD_ottawa]

re boot the profilux, it will tell you what version on boot up.

go to profilux control then display and tick the parmemeters you want displayed

 

[StevieK]

please note that i am further along than just posting question here:

i of course ticked the parameters and it is not showing ... software glitch?

when i reboot it just says version 5 ... should it say 5m ?

 

[AQD_ottawa]

not software glitch otherwise nobody would see the temp. Most likely you have de activated the temp probe.

More support please only here www.aquariumcomputer.com/forum

 

[Ken Good]

not software glitch otherwise nobody would see the temp. Most likely you have de activated the temp probe.

More support please only here www.aquariumcomputer.com/forum

I did this and had the same problem. If you go into the profilux software and go to the temperature "page" there is an option to activate or deactivate. See if you selected deactivate. If so then that was your problem.

Ken

 

[StevieK]

not software glitch otherwise nobody would see the temp. Most likely you have de activated the temp probe.

More support please only here www.aquariumcomputer.com/forum

tried that, someone moved or deleted my post
will try again here as it seems to be a little more oportunity for information received

but thanks for your help

S