Light Mounting Options

[GoJo]

I am setting up a 4 gal pico tank using an Eheim Aquastyle that was sitting dry with an AquaClear 70 hanging on the back. The AquaClear works great for flow and allows enough room to put a small heater in along with some ceramic biomedia and keep everything contained.
The problem I have is that the AQ70 takes up the entire width of the tank and leaves no room for mounting a light. I have a Zetlight 1201 for lighting. I thought it could mount to the back wall of the AQ70, but the filter housing is too deep for the arm to reach.
Anyone have any light mounting ideas they have used that might help? I am considering adding something to the filter housing if I can figure out what that might be.
Thanks

 

[GoJo]

Here is where I ended up.

• 4 gal AquaStyle cube
• AquaClear 70 HOB filter
• Zetlight 1201 LED light

The light mount would not reach from the back of the AQ70. So, I took advantage of an existing ledge by the return and attached a cross member of 0.22 acrylic. A little bit of a Frankentank, but I think it may work.