Light sensor problem

[africangrey]

Hi Roger,
I have an older controller 7094 with basically a new light sensor I got from you about 3 month ago, but my 2x 6100 and wavebox have been alternating during night mode when light goes off, the only thing is that the wavebox won't come on for hours during that time and make the tank run almost stagnet for 3-4 hours. when the 2x 6100 are on they operate at low power not pulse.
It's there anyway I can get only the 6100's running constantly which is how the contoller should behave at night mode. By the way, the 6100's are occupying channel 9 and 11 and wavebox is on 8, even when I swith the channels, they still alternate.

 

[rvitko]

Is the wavebox running with it's own photocell? What mode are you in?

 

[africangrey]

wavebox is pluged with its photocell, that's why it is shut down at night even the controller signals it to come on. It is operating in interval mode. The stream are on 9 and 11, while the wavebox is on channel 8.

 

[rvitko]

Normally in night mode when using Interval mode the sockets 8 and 10 are on and 9 and 11 are off, you might try reversing that. I would suspect that the wavebox being off on it's own controller might cause an interruption, try running the wavebox without it's photocell and the night mode should turn off the channel that powers it. Also make sure that the wavebox controller was switched to extern, synchron is the default.