jnarowe
New member
Below is my statement series to control the re-start of my halides, but something is not going well. I have used this statement since I first started about 2 years ago, but have recently lost two lamps when the power came back on. I know that the re-start may not be what blew the lamp, and that it could be one of the many spikes I have had recently blowing all sorts of equipment, but today I was present for a power outage and watched the restart.
All the lamps listed restarted at the same time!
If Power 000 Then LT1 OFF
Max Change 010 M Then LT1 ON
If Power 000 Then LT2 OFF
Max Change 015 M Then LT2 ON
If Power 000 Then LT3 OFF
Max Change 020 M Then LT3 ON
If Power 000 Then ALM ON
So does anyone know what is wrong with this code?
All the lamps listed restarted at the same time!
If Power 000 Then LT1 OFF
Max Change 010 M Then LT1 ON
If Power 000 Then LT2 OFF
Max Change 015 M Then LT2 ON
If Power 000 Then LT3 OFF
Max Change 020 M Then LT3 ON
If Power 000 Then ALM ON
So does anyone know what is wrong with this code?