reefnewbie83177
New member
I don't know if I should be posting this here are in the lighting/equipment section, but here goes. I set up a DIY LED system with Meanwell 60-48P drivers. I am trying to find information on how to connect these to my Profilux. I know I need to purchase the LEDcontroller4 v2, but I just want to make sure that this controller will work with these drivers. It mentions that it can take an analog signal and convert it to PWM, but the 60-48P driver is a PWM signal. If anyone has any experience with this type of setup, your help would be greatly appreciated.
Last edited: