mechanical mounting info needed

[ronc98]

I have a wavebox on order and I am to a point where I am building the overflow box for my tank. It will be mounting in the middle of the overflow box. I know there are mounting holes on the back of the wavebox I need to know where they are located in regards to the wavebox. I need to drill the holes inside the overflow box before I stick glue it into the tank.

Does anyone have any of this info. I need to know with pretty good accuracy. Once I have the overflow box mounted I can not take it out.

I am still about three weeks away from getting my box and I can not wait until I get it.

A manual would be greaty if anyone has one I could take a look at.


Thanks

Ron C

 

[rvitko]

The rails are an 1" wide and the dimensions from the outside of each rail is 3.5" and from the inside is 1.5" I am working off a prototype and these are unlikely to be 100% accurate, this info was posted here previously though by an end user with exact metric measurements. I would say just make the holes 1.25" and you will be fine.

 

[ronc98]

Thanks. That will give me someplace to start with.

R