Moonlight Problem

[stevem650]

I have the 7095 controller and my moonlight will only work when I unplug my 2 6000's. It will come on for only one day and then not come on again until I unplug the controller. Also, sometimes the moonlight will come back on for a night after a week or so. I do have a closed canopy so any outside light should not effect the moonlight. Can it be a bad photocell or controller? Thanks Steve

 

[rvitko]

I am puzzled as without the pumps plugged in the unit should recieve no power and not run at all? The moonlight does brighten and dim througha 29 day lunar cycle, verify it is not on but very dim. Make sure that the moonlight LED is on on the controller so that this mode is actually functioning.

 

[stevem650]

Roger...thanks for the quick reply...The only way I can get the moonlight to work is to unplug the power to the 2 6000's and then plug them in again. This also shuts the power to the controller which seems to reset the moonlight. The moonlight will light only for 1 eve and then never come on again until I unplug the streams which shuts down the power to the controller. The moonlight and night mode LED's are on. Thanks

 

[rvitko]

That is strange, I haven't seen this problem before. Can you send it to me for repair?

Tunze USA
305 Victor St
Austin TX 78753

 

[stevem650]

I will get it out to you. Thanks Steve

 

[stevem650]

Roger...Thank You..My moonlight is working again..

 

[rvitko]

Good to know!