More than minimal flow in interval mode

[rsaha]

I have two 6105 and a 6055 on a 7096 running on interval mode. I would like to up the flow (everything is maxed) by increasing the flow from the pumps that are in non-pulse mode (i.e pump 1 is ramping from 30-100 and pump to is running min flow - I want it at 50%). In interval mode is there a way make pump 2 run at higher than minimum flow? I've tried setting pump 2 to 100 max, 100 min and min flow turned on to see what happens and I get min flow. I tried min flow off for pump 2 and no matter what min I specify the pump turns off. Am I missing something?

 

[rvitko]

The only way would be pulse mode, Interval switches between two pumps and the other pump is either off or at idle of 30%.

 

[rsaha]

As feedback for the next release, it would be nice if this was supported.

Is 30% on a 24V jumper higher than the minimum flow quoted for this pump (792GPH is quoted for both the 18V and 24V in the manual)?

 

[rvitko]

The minimum flow is 30% at 12V, the maximum stated is 100% at 24V.

The 7096 has a limited amount of memory so their are limits to the features we can add but I will mention it.