Mp10 flashing green/red

[Dashiki]

I have an mp10wes that won't reset and is stuck blinking red/green

Any tips or thoughts?

 

[Alex Y EcoTech]

Dash,

Have you tried powering down your MP10 and running the unit without the wetside attached? If that seems to correct the red/green stall error, you will need to clean your wetside thoroughly. If the issue persists I would recommend calling us directly 1-800-785-0338 Ext. 2.

 

[byrdman81]

Hate to high jack a thread but I have the same issue and I tried the method above of separating the two halves. I still get the red/green light. Im assuming I need to purchase another controller?

 

[Alex Y EcoTech]

byrdman81,

Please contact us directly so we can discuss your replacement options. 1-800-785-0338 Ext. 2 or service@ecotechmarine.com

 

[EasyEd77]

Not sure if anyone will see this but my MP10 W will flash white green red and then stall. I have 2 wet sides I swap out and I just put one in that is clean and spins easy. It only does this at high speeds. When it is set around 50% there are no issues.