Joeb1983
Member
Posted this in Ecotech as well, but I have 2 mp40's with upgraded Quite Drivers paired running anti-sync.
For some reason my slave pump keeps reverting back to the lowest speed and staying there no matter what mode I place the master in.
The dial remains orange indicating slave relationship and the "W's" are lit on both drivers, but like I said; it stays at the 1st dot speed making one side of my tank dead for flow.
This used to happen once in a while and I would simply cycle power and all was well.
Now its taking a hard reset and re-pairing which will last a week or so.
RF modules are correctly and securely installed as well as all connections.
Drivers are ~ 5.5 ft apart in cabinet.
Any ideas? Did it again today...
For some reason my slave pump keeps reverting back to the lowest speed and staying there no matter what mode I place the master in.
The dial remains orange indicating slave relationship and the "W's" are lit on both drivers, but like I said; it stays at the 1st dot speed making one side of my tank dead for flow.
This used to happen once in a while and I would simply cycle power and all was well.
Now its taking a hard reset and re-pairing which will last a week or so.
RF modules are correctly and securely installed as well as all connections.
Drivers are ~ 5.5 ft apart in cabinet.
Any ideas? Did it again today...
