multicontroller 7094

[eschreib]

Using to 6100's, aimed as suggested, can you provide some information on the 'suggested' settings for the 7094?
I'm really stumped, and have gone through the manual, and have spent hours twiddling with it, but I'm not sure I even understand the basics of the settings.
Any help or advice greatly appreciated.

eas

 

[rvitko]

I would use either tide mode where one pump is in the first socket and one in the last and then you program a pulse frequency from 1-7 seconds. I usually go with 3. Then you program each pumps pulse width as 30%-100% twice- so you have a low speed and a high speed the pump pulses between. Then you set an interval which is the time between the pumps switching on, so one pump is on for the interval and then they switch after the interval is up. This is set first with a switch and then you dial in a range between the switched interval with the knob. Tide mode is the mode with two arrows pointing at each other.

Pulse mode is the preffered option if you have little critters than can get in the pump as the pumps just pulse and you can set an opposite pulse so when one is fast the other is slow and this mode does not use interval features at all.

 

[eschreib]

Thanks ROger!
Very helpful.
Is there any additional documentation or information available on the multicontroller beyond the manual that comes with the unit?

thanks again

 

[rvitko]

No, I am writing the next manual and hopefully that will make it improved but odds are I will miss somethings and for the other languages there will be things lost in translation from English since this will be the first time a manual was first done in English. Feel free to ask any questions though and if you need to call it is no problem. Just keep in mind we are closed Monday and Wednesday I head up to Chicago for IMAC and won't be back until Monday since it is about a two day drive.