Shrooms are by far one of the easiest corals to remove and relocate. I have done so more times than I can count. Wearing your reef safe gloves and eye protection, prepare a clean hard surface, preferrably a concrete floor. I use a concrete block I keep on hand. Using the proper size chissel, placing it at an angle at least 1/2" from the mushrooms in question, chissel some rock from the mother rock around the polyp, being careful not to damage the flesh of the mushrooms. It's best to leave the rock chips attached to the shroom to help secure it to a new rock later. If you are going to reattach them to a new rock today, place them one by one into a shallow bowl filled with tank water until you have removed the last shroom. The mushrooms will begin to slim as this is mormal as they are stressed.
Prepare the new rock on the hard surface. Using paper towel, pat dry the areas you wish to relocate these chips to. Remove and lay the mushroom chips on some dry paper towel. With proper spacing, apply a small amount of reef safe glue or epoxy to both surfaces and press for a few secs. Only apply the opoxy to one surface, preferrably the mother rock. Place the rock on the substrate, in line with good current but not overpowering as this current will help remove any slime being secreted. Leave the rock on the substrate and do not move it. I'd leave it there for several days. Prepare a new spot on your reef, then set it and forget it. Run your actinics only for a full photo period for the first two days post op. :wavehand:
Good luck.
What are reef safe gloves exactly? I know certain corals can give off a poison, but what type of gloves should you use?
Mooch