Justin74
New member
Heres my last years upgrade to breaking down an old fixture and retrofitting my lamps
Due to lack of supplies and sheer exhaustion I had to leave some of the fixture on, which was cool at the time because it kept most of the wirring together but was a major hazard(loose) and an obstruction to the fan from cooling the bulbs and ballast. So then I did this
Whatya think?
Theres three ballast there kinda hard to see, and once I come across some conduit I may mount over some of that with it to further "clean it up" in the cabinet area. Next move will be to mount the electrical in there, just means Ill have less room for my miscellaneous junk.
Due to lack of supplies and sheer exhaustion I had to leave some of the fixture on, which was cool at the time because it kept most of the wirring together but was a major hazard(loose) and an obstruction to the fan from cooling the bulbs and ballast. So then I did this
Whatya think?
Theres three ballast there kinda hard to see, and once I come across some conduit I may mount over some of that with it to further "clean it up" in the cabinet area. Next move will be to mount the electrical in there, just means Ill have less room for my miscellaneous junk.
Didnt know this till later in the hobby, but where your light is is where my water drains into, I also dont have that extra chamber for skimming to the left of where your media tray went, I was thinking of doing that and making a fuge but I would have to flip everything around and with my DIY list just getting bigger I may never end up doing it.
