So I glued my baffles in on Sunday, it is now 48 hours later and they are more than dry. Did a leak test and I have 3 leaks.
The red circles indicate where the leaks are... unfortunately they are all on the side that I was working from, probably why they leak in the corners. They are slow leaks but leaks none the less. The DT drains in the the drain section, overflows into the fuge section, overflows into the return section.
How important is it to seal these leaks? Like I said they are slow leaks, the strength of the baffles appear to be good because I pulled on them quite a bit with water filled in that particular section.
My reasoning being since water is flowing and is filling the following chambers, why do they have to be absolutely sealed?
Any help is greatly appreciated, looking for an answer tonight! Under a huge time constraint and I have a busy schedule for the next 2 weeks.
The red circles indicate where the leaks are... unfortunately they are all on the side that I was working from, probably why they leak in the corners. They are slow leaks but leaks none the less. The DT drains in the the drain section, overflows into the fuge section, overflows into the return section.
How important is it to seal these leaks? Like I said they are slow leaks, the strength of the baffles appear to be good because I pulled on them quite a bit with water filled in that particular section.
My reasoning being since water is flowing and is filling the following chambers, why do they have to be absolutely sealed?
Any help is greatly appreciated, looking for an answer tonight! Under a huge time constraint and I have a busy schedule for the next 2 weeks.