Neptune breakout box delay?

[hipertec]

I just hooked up a breakout box to my PM1 that is connected to my Apex Jr.
Testing via a water sensor and float valve.
Both works but it take about 40-50 secs before if goes from open to close.

Anyone know what is causing this delay? Is there like an update that needs to do done to is or?

 

[jonmos75]

If you are using Fusion that delay is normal and can some time take longer to show the change. It happens instantly in the Apex. When testing it is best to use Apex local as the data does not have to travel as far and go out to the internet. When using Apex local it changes quicker then Fusion.

 

[hipertec]

Thank you. It turned out it was that delay to the cloud. All works instant when plugged in to test.