New 7095 and 6055 and a click click click

[2turtles]

About three weeks ago I bought one 6055. Nice little pump and it moved some water and seamed pretty quiet. So I just bought the 7095 controller and a second 6055. Set them up to alternate back and forth. Every time they start up I hear this click. Once every thirty seconds is very annoying. The newest 6055 also seams to hum a bit. Is ether of these two things normal? (I hope not)

 

[shawnz28]

The nanostreams all click at startup. It is basically them righting themselves so they dont spin backwards. Try setting the controller to interval 2, this way they never fully stop

 

[2turtles]

Thanks Shawn! That solved the "click" now I just need to resolve the hum.

 

[shawnz28]

give the new one some break in time. seems to help

 

[2turtles]

OK will do. Another 7095 question. My goal is to have the one 6055 come on full speed for about five minutes while the other is just idling. Then to switch with the other on full speed for about five minutes and the other idling. All I have been able to obtain is a pulsing action. I have figure out the back and forth timing but instead of the pump running full speed for five minutes it pulses. If I turn up control 1a or 2a that gets around the problem during the day but then at night they are still running full speed. I hope this makes sense.