New 75G, Not Level

[Riptide10]

I got this 75G marineland on sale. After getting it home (naturally) I noticed the tank isn't level in the stand. The center brace has a high spot so the tank see-saws over it. The gap is almost 1/4".

What is the best way to address this issue? I would prefer to not exchange if that can be avoided.

 

[rjjr1963]

Electrical sander or a hand planer.

 

[bill120reef]

How is the brace attached? I would remove it and cut to proper size.

 

[bill120reef]

before cutting be sure the joints didnt separate while you where moving it, You could try placing a block of wood above the brace on top of the stand hitting it down with a hammer, the block of wood will prevent damage from the hammer to the stand

 

[Riptide10]

Brace is attached with staples. I dont know if glue was used. Pulling the staples will be difficult without damaging it but may be possible with care.

3/4 corners sit flush. Just this one edge is warped up.

 

[bill120reef]

I would return it in that case.

 

[Riptide10]

I am reading that glass tanks don't need support in the middle? Can I just tear this brace out then?

https://www.monsterfishkeepers.com/...uarium-support-under-the-corners-only.353909/

I'm attaching a photo of the stand to see how it is put together.

 

[bill120reef]

that would be up to you. I have no way of knowing that answer, If it was me and I just bought something brand new and defective I would return it.

 

[bill120reef]

also, be sure the tank is not following your floor, it could be your floor is out of level and the stand is shaping to it, if so, properly shim the stand. I think stands are made pretty flimsy by mass producers and would not recommend removing any support from them

 

[Riptide10]

If I knew the brace would come out without too much trouble I'd be tempted to effect a replacement. The issue is definitely with a warp in that cross brace fyi, not the floor.

I'm reluctant to return since I had to get help from someone to drive this over. I don't have a vehicle that fits it. So, this is going to be a hassle then. Bummer.

EDIT:
I am tempted to get a wood block underneath it and pound the cross brace out. If it breaks or leaves behind glue and bits of wood I can always work it over with a Dremel. Then, replace it.

 

[bill120reef]

My last Thought/comment about your stand, It may be a few days of trouble to exchange it but a tank is meant to last for many years, I would not risk a poorly made stand under the weight (almost 800lbs)
Good luck with whatever you choose to do.

 

[frank2926]

I have removed those braces on several stands to get sumps in. I just knocked them out with my hand, as you said they are just held in place with basically staples. I have always either put it back with a few screws, or replaced them with a new piece due to the edges being frayed/warped.