New ProfiLux Update

[janey]

Ok I did a Factory reset and installed the firmware again..
Im getting an alarm PABCOM

My power bar is not turning on... I see the green light flashing..
I installed my saved file setting to the P3

 

[KevinJ]

Ok I did a Factory reset and installed the firmware again..
Im getting an alarm PABCOM

My power bar is not turning on... I see the green light flashing..
I installed my saved file setting to the P3

Ok I know this is a silly question but did you remember to reconnect the PAB cables to everything?

KevinJ

 

[Matthias Gross]

you updated only the Touch, right?
and the powerbar was disconnected during the update?

the LEDs indicate that there is no communication - please check the cables

 

[janey]

ok GOT IT TO WORK!!!!!
Thanks to Madehtsobi

go download...Powerbar6D-PAB_V108.mhx

then load ghl control center

unplug everything from p3 unit except the cat cable to the pab..even unplug the power to the pab unit itself
click on EXTRAS on the tab then click on the FIRMWARE update for the PAB
agree and confirm
select that file from above
itll ask if u want to update...click yes
itll pop up saying no PAB connected try again?

this where u plug in the pab unit to the socket and right when u do click OK

and VOILA!