Came home one evening and the alram was going off on one of my streams, so i cleaned it and it is working fine. But the other one would not run and i noticed the driver and transformer were very very hot! So i unplugged all connections for that stream and let sit for about an hour to cool. Plugged back in and still will not run, but i also noticed the 7095 was flashing lights and the other stream stopped working again. Once i unplugged the stream that was orginally hot comletely from the 7095 the other stream is running fine. For now i am just running on one stream but the other one will not run. Please advise. I purchased the stream kit from Marine Depot on 8/2006.
Not sure what's wrong.
- Thread starter dstall
- Start date
Hello, have you remove both stream and give it a thorough cleaning. You can follow the sticky above on cleaning procedures. Also check for moisture, salt crib or any loose connection... Once you exhausted all possibility and it still don't work, send them in so Roger or Rodney can take a look at them.. Hope they still under warranty..
Roger
I really appreciate fixing the driver on my Tunze stream last month, but you’re not going to believe this the other stream just stopped. It is doing the same as the other one in that the driver and transformer are very very HOT. I did clean it thr stream thoroughly to make sure but it will not run and the driver and transformer heat up the minute I plug it back in.
Should I do as instructed for my other streamer and mail everything to you? Please advise.
Thanks
I really appreciate fixing the driver on my Tunze stream last month, but you’re not going to believe this the other stream just stopped. It is doing the same as the other one in that the driver and transformer are very very HOT. I did clean it thr stream thoroughly to make sure but it will not run and the driver and transformer heat up the minute I plug it back in.
Should I do as instructed for my other streamer and mail everything to you? Please advise.
Thanks
Similar threads
