Amoo
Member
Maybe something like this from Lowes:
Diamon Wheel
I personally would put some rubber or something soft in a vice, add my acrylic to the vice, then go at the acrylic at an angle with the dremel diamond wheel, cutting out the slots I wanted.
Maybe also look into this:
Multipurpose cutting bit
Or maybe take a flier on on of these and hope for the best:
Steel Engraving Bit
The important part to remember, assuming I'm reading the design correctly is to ensure you cut at more of a 30 degree angle or so, as opposed to a 90 degree angle.
Diamon Wheel
I personally would put some rubber or something soft in a vice, add my acrylic to the vice, then go at the acrylic at an angle with the dremel diamond wheel, cutting out the slots I wanted.
Maybe also look into this:
Multipurpose cutting bit
Or maybe take a flier on on of these and hope for the best:
Steel Engraving Bit
The important part to remember, assuming I'm reading the design correctly is to ensure you cut at more of a 30 degree angle or so, as opposed to a 90 degree angle.
