oops. I need a new impeller for my stream

[rtbm]

while I was reassembling my stream impeller after a cleaning I must have screwed the screw that holds the propeller piece on a little off. It seemed tight but stupidly I kept turning. The screw snapped half inside the white piece. the pump has always been a little noisy because of a small chip in the magnet so I figure I might as well get a whole new impeller. How can I get one?


Thanks,

Adam

 

[rvitko]

At the moment the only part I have to get you running is 6080.64 and 6080.641- a new shaft and screw. The drive unit 6100.60 is what you have, 6100.70 is the more current version and will fit. Both will be in next week. I might suggest ordering a 6080.64, 6080.641 and 6100.70 on tunze.com. The order comes to me, we will ship what we have and ship the 6100.70 later at no extra charge.

 

[rtbm]

Sounds good I will give you a call there.

Thanks,

Adam

 

[Lutefisk]

I just had the same problem and ordered those for myself.

What is the part number for the little red o-ring that sits at the base of the impeller?

Paul

 

[rvitko]

3000.612, I did get your order, we should get it out Monday.

 

[Lutefisk]

Sent you a PM hoping you can correct my order for the right o-ring.


Thanks,
Paul

 

[UNCFAN]

I recently ordered (1) 6060.120 and (1) 6080.120 impellers at tunze.com. Will these ship from USA? Are these a stock item?

 

[rvitko]

We mailed them to you yesterday.

 

[UNCFAN]

Wow thanks for the speedy delivery!!!!