tripnbili
New member
I have a pacific coast imports regulator on my Ca reactor. I have everything set-up the way I want to start with, BUT the output pressure is around 35 and of course I need it down around 15-20. With this regulator there is no obvious mechanism to control operating output pressure. There is a pre-set screw underneath the regulator, and I have tinkered with it, but to no avail. And yes, when I tinkered with it I opened up the solenoid to allow a decent amount of gas to escape so the gauge would read the new pressure, but no change.
Does anyone have one of these or have experience with one? I have contacted the manufacturer, but of course it is the weekend and I don't expect a response for a while. Here is a link to the regulator
Does anyone have one of these or have experience with one? I have contacted the manufacturer, but of course it is the weekend and I don't expect a response for a while. Here is a link to the regulator
