plumbing mistake,help me find a part...

[WarDaddy]

I blew it, was sleeping while glueing and forgot to put a Valve in.

Now I need to get a 3/4" barbed valve for 3/4" tubing.

Anyone see one of these, ever?

 

[SPSFiend]

Are you using vinyl tubing?

 

[818]

No.

Get a 3/4 threaded valve. with threaded barb fittings. Whats this application for?

There are so many other alternatives than going out and spending money.

Let me know I'll help you out I might have what your looking for lying around.

Sam

 

[SPSFiend]

Oops, I had not finished...

Also, is it a check valve you want to put in? If so I guess you could get a check valve and two male barbs. Just glue them into either side of the valve and you could install in the line?

 

[Fmellish]

Use the standard 3/4" male hosebarb fitting. It's hosebard on one end and MPT on the other end. on either end of your PVC valve install these fittings. That's it. Then you have a valve with hosebard on either end for hooking up in the middle of soft plumbing.

I used to use a valve between my skimmer pump and skimmer which was all soft plumbing.

Josh

 

[NicoleC]

Bryan, didn't the skimmer setup have two 3/4" hosebarb to MPT connectors already?

 

[WarDaddy]

Nicole, not your skimmer, it is perfect.

I need to reduce flow to my cube. I have vunal tubing running to it. I think I may have a solution... but it is more threaded PVC, yuck.

I will give it a try this weekend... yikes.