PowerBar socket state while Profilux boots

[KimmoS]

Hi,

Would it be possible to prevent Profilux from switching the socket outlets OFF on PowerBar6D when Profilux is restarted?

The PowerBar works great by switching to the "safe-mode" when the connection to the Profilux is lost, but as the Profilux comes back online and connection is restored, Profilux sets all sockets to OFF state.

This is a minor annoyance when I'm doing tank maintenance in the evening that requires shutting down the Profilux and as the Profilux is restarted all tank lights go off for a short period of time.

 

[Matthias Gross]

no, i am sorry because ProfiLux doesn't what which state is correct in the first seconds - what should he do with heater or magnet valve for example?

But you can do this: unplug the control line, plug it in again some minutes after ProfiLux has rebooted

 

[KimmoS]

OK, that is what I was suspecting. Your trick with the control cable will solve the problem! (if there even is a problem ) Thanks.

However, I thought that Profilux should be turned off before a device is connected to it. Last time I had to turn it off, I was adding a new level sensor.