skairik
New member
Long story short, my Profilux Ex II failed midway through an update that was admittedly my fault. That has since been corrected though by using a Jumper Pin to re-flash the controller with FW ProfiLux II, Version 5.08a (ES+ENG). PC software is ProfiLuxControl, Version 5.1.0.0. The device driver is PL-2303. Profilux boots up just fine. The problem is that I can't get the controller and the PC to communicate. I've already tried without success using the other driver on GHL's downloads page (Driver for PLM-USB and integrated USB-port of ProfiLux 3, Treiber für PLM-USB und für integrierten USB-Anschluss d.PL3)
Previously I used the same cable when I was using ProfiLux II, Version 4.08 so I'm assuming that the problem is not related to the serial cable. Does anyone have any idea what the solution would be?
Previously I used the same cable when I was using ProfiLux II, Version 4.08 so I'm assuming that the problem is not related to the serial cable. Does anyone have any idea what the solution would be?
