I have a Profilux Plus II, which I purchased with WLAN and cond/redox cards. I subsequently added an additional pH card and upgraded to the IIex.
I have two pH probes attached and they show in the probe/sensor list as pH 1 (sump) and pH 2 (calcium reactor).
Although the cond/redox card is recognized on boot, and shows in the system list, I only get a single probe Redox 1 showing up in the probe/sensor list. This is the one connected via the IIex expansion module, which is in my sump. I have attached a second redox probe to the upper BNC connector on the cond/redox expansion card, which I had not been using since I upgaded to the IIex, for use with a nitate reactor. What must I do to get the Profilux to recognize this as Redox 2 ? It will be running with very different settings with negative oRP.
I've tried rebooting the Profilux, but it still does not recognize redox 2. The card was working fine before I did the IIex upgrade, and is recognized during the boot up process, it just won't give me another probe to monitor.
Thanks.
I have two pH probes attached and they show in the probe/sensor list as pH 1 (sump) and pH 2 (calcium reactor).
Although the cond/redox card is recognized on boot, and shows in the system list, I only get a single probe Redox 1 showing up in the probe/sensor list. This is the one connected via the IIex expansion module, which is in my sump. I have attached a second redox probe to the upper BNC connector on the cond/redox expansion card, which I had not been using since I upgaded to the IIex, for use with a nitate reactor. What must I do to get the Profilux to recognize this as Redox 2 ? It will be running with very different settings with negative oRP.
I've tried rebooting the Profilux, but it still does not recognize redox 2. The card was working fine before I did the IIex upgrade, and is recognized during the boot up process, it just won't give me another probe to monitor.
Thanks.
Last edited:
