Re-using sand

CoreyK

New member
I recently had to move apartments and the way I move my tanks is to place all the inhabitants in equal tanks at my parent's house, then move everything back into the apartment tanks once they're re-set up.

I know the general consensus is to get new sand (aragonite in my case), but my 20g was only set up for about 8 months so it's not *that* nasty.

Should I stir it up and re-use it, or get all new sand?
Thanks!
 
I'd reuse it. Just make sure you check for a cycle because I'm sure you have some die off which will cause a spike.
 
That is a can of worms. You may be just fine but it is potential trouble. It is not so much a cycle to look out for but what is trapped in the sand. You may release bound up phosphates or possibly sulfates if there were any dead areas in the sandbed. You could certainly minimize these by rinsing with saltwater. But you will always be safer replacing it with new sand IME.
 
For the record I am replacing mine with new aragonite. I got 40 pounds cheap enough. And I believe it releases Calcium and other trace elements into the water over time.

Sand is pretty cheap. One of the cheapest items in this hobby. :)

I replaced 12+ pounds at once in my 29 a few days ago and no cycle whatsoever. But I also have 47 pounds of live rock. And I only replaced a small section. I like to go slow with anything related to reefs... Maybe like another month before I replace more. I'm not in a hurry.
 
Last edited:
Reuse and recycle and when I say recycle I mean cycle....

You can cycle the sand just like you would rocks. Put a pump at the bottom of a vessel i.e. 55 gallon BRUTE can, then run a tube off the discharge of the pump so that it is higher then the level of sand, and treat it as if you were cycling rocks. We do it all the time to create live sand, and have never had any problems....YET

Just my two cents
 
Back
Top