Reset 6105 to factor

[sticky]

Is it necessary to reset the 6205 to factory after adjusting to run the 7095 multicontroller? I would rather run the pumps on the included controller instead.

Thanks

 

[rvitko]

I don't understand the question. The 6205 is too old to have a built in controller. If you have a newer pump with a 7090 you just disconnect the 7095 and use the 7090 and it will work correctly.

 

[sticky]

Sorry, it was a typo. 6105 with controller. I had adjusted it to work with the 7095 which did not meet my needs so I wanted to go back to the original controller supplied with the pump and wanted to make sure I did not need to change anything back.

Thanks.

 

[rvitko]

If you just disconnect the 7095 and change it to a mode besides External it should work as it did.