I have no experience with Ro/Di units, I purchased this one used from a local RC member, I just replaced the filters (not the membrane). The pressure on the gauge reads 40-41 PSI. Here it is. http://www.purelyh2o.com/index.php/h2o-test-meters.html?page=shop.product_details&flypage=flypage.tpl&product_id=23&category_id=7&vmcchk=1
Ok. My problem is, I am not producing any water. It gets past the Ro membrane ok, but its not making it through the Di chamber. I know it worked before I changed the filters, so I wondered if I packed the Di resin to tight (is that even possible). Could it be a pressure issue. I noticed that when I placed the unit higher the Di chamber would start to fill and then an air bubble would come from below and the water level would be lowered and so on. Any help would be greatly appreciated.
Ok. My problem is, I am not producing any water. It gets past the Ro membrane ok, but its not making it through the Di chamber. I know it worked before I changed the filters, so I wondered if I packed the Di resin to tight (is that even possible). Could it be a pressure issue. I noticed that when I placed the unit higher the Di chamber would start to fill and then an air bubble would come from below and the water level would be lowered and so on. Any help would be greatly appreciated.
