(Roger) Help With Tunze controller settings!! :D

[pmike25]

Hello all (Roger), I have a question. Ive been reading the instruction manual for the Multicontroller and just can seem to understand it or something. OK let me 1st say what kind of controller and pumps I have, I have the 7094 controller and 2- 6100 Stream Pumps. I am keeping Acros, Toadstools, Frogspawn, Millies and some softies like Zoas (more frags than anything, since I just started this system about 3 months ago). I want to know what is the best setting that the controller should be on for what type of corals I have.

Can someone please explain to me what the setting should be. Right now I have them set as follows

I have each pump on seperate sides of the tank. They are approx 3/4 the way to the top of tank and in the middle of the sides. I have them run full blast on one side and low on the other, than they switch the same way. OK hope your staying with me so far. The Mode switch is in the middle and the Interval switch is to the top 1-12 hours, but they switch every 13-14 seconds, whay that is I have no clue when there on the top which is 1-12 hours.

Bascially what Im asking is for the types of Corals I have which is the best setting to have healthy Corals.

Heres some pics to show you the controller and where the pumps are located

THANKS IN ADVANCE for the help!!! Sorry for the long post!!

The red dots are representing where those knobs are set at. Now the interval light isnt on because of I have the pumps on ports 8-10 I think they come on when you have them on 8-11

 

[rvitko]

You need to set mode to the top, which is tide mode. I would also turn pulsing on, right now the bottom knobs are not really doing much, with pulse the pumps go from top to bottom setting every few seconds. In the middle is pulse mode so Interval does not apply, if it is sequence the interval setting is only applicable with 4 pumps. I could email you a manual if you provide an address.