Roger-new 6055 not working

[eburgiss]

Roger, I put my 6100's in the box today for 2 new 6055's. One of them is not working properly. When I remove the propellor and put it back, sometimes it will work. They are connected to my 7095.

Should I try to get my LFS where I purchased them to replace or do I need to send to you for replacement? I don't think I'm doing anything wrong because my 6100's worked fine. Please advise.

Thanks in advance.

 

[rvitko]

Does the light on the transformer come on? If no, this is the likely problem, if yes I would try using the drive unit from the working pump and see if we can narrow it down, if it is just a bad drive unit I can send you one. If the magnet is cracked or the prop is broken it will not work.

 

[eburgiss]

Both power supplies are working. I checked the magnets and they are not cracked. I spoke with my LFS today and they said since I just picked them up, they would swap out with me.

I thought I had read on one of the threads they were some improvements on the newer 6055's. How will I know if I have a new one or old one?

Thanks.

 

[rvitko]

Basically just the drive unit was changed, newer ones the prop is pressed firmly on the drive unit so it cannot move so easily and click on start up. You can move it by hand but it is not free spinning.