Safety Connector

[carlosml]

How to install a system to power the pumps Tunza with a battery in the event of electrical failure with the Safety Connector, is possible with solar panel, somebothy , someone has photos, diagrams that can help me, thanks

 

[rvitko]

For a solar panel you would connect the solar panel to the battery to charge the battery and then connect the battery to the safety connector. What model pump do you intend to use and how long do you need it to run without power?

 

[carlosml]

Thanks, i would like about 24 hours, i have a ups, and i'll conecct the batery direct to de the conect, but i dont understand well de scheme of connection and if the controller 7095 need too energy, have the controller some funtion when the energy go off, The main problem is that when I'm away from home is when there are electrical problems and I like to travel with the reassurance of having a battery backup for the pumps, if I can also charge the battery with a solar plate, would be a perfect solution for electrical fault

 

[rvitko]

What model pump will you be using? I need to know so I can figure out how big of a battery is needed for 24hrs of run time.

 

[carlosml]

Thanks, i have two Turbelle stream 6105

 

[rvitko]

For each 6105 you would need a 6105.50 safety connector, to run for 24hrs each pump would need a battery of about 28-30 Amp Hours. You could use two of these:

http://www.batteriesplus.com/pc-326...ttery w- Nut Bolt Terminal - WKA12-26NB.aspx

Or you could wire both safety connectors to one of these.

http://www.batteriesplus.com/pc-23891-23891-8016-103.aspx

You would additionally wire the solar panel to the battery

http://store.sundancesolar.com/poror15wafls.html