Setting up tunze's on magnet holder, a question..

[TrojanScott]

Just got my magents for my new 6000's. Unless I'm missing something, is the screw that's supposed to connect the stream to the plastic part that sits in the magent, not even needed? When I attach the two parts, I could, if I wanted, just pick the stream off the magnet and holder, and the screw would remain. Am I correct? It doesn't seem there's a way to screw down the stream so even if I tried to lift it off, I'd have to loosen something? (with the parts provided anyways)

Hope that was clear, hard to explain.

Thanks.

 

[BlueCorn]

No screw required. The stream should just slip over the pin.

 

[TrojanScott]

Okay, thanks. The booklet says to put the screw in there to stabalize it, guess it doesn't hurt, but just wanted to make sure I wasn't missing something, considering I'm not using most of the parts the streams came with!

 

[rvitko]

The screw is only included with the 6200.