Skimmer Problem

ykh

New member
My AquaC Remora skimmer is acting weired. Instead of skimmate filling the collection cup and it's filled with lots of water. It just happened since last nite, weird.

Any suggestions to fix this prob?
 
This happened to me and flooded the floor. I accidently knocked the "ledge" where it controls the level of water and bubbles going over to the trickle side so it was higher than normal.
Not sure if that applies here, hope you can find the cause.
 
Certain foods and a change in the salinity of the tank water (among other things) can trigger this to happen. Have you done anything out of the ordinary lately?
 
an obstruction blocking the inlet for air will cause pure water at pressure to fill up the skimmer.
 
Thanks everyone for your suggestions and feedback. I did glue some frags down lately:) I just raised the collection cup and see how it goes.
 
Back
Top