Thoughts on this setup please..

[Saldarya]

Roger,

Considering the current wait on streams, I have an opportunity to purchase a 6200 that I could use on a single controller. I would like to use this in conjuction with a wavebox (when it becomes avail). Tank stats are:

110g 60"x18"x24" center overflow box
approx 1500 gph return (not much velocity here)

thoughts? especially as to the best placement of the 6200, thanks!

Robert

 

[Saldarya]

Additionally, I may just go with 2-6200s and wait on the new controller (it is a barebotom tank). I have a concern as to whether I will have the top clearance for the wavbox as the tank is perimeter braced. So, in addition to the above post, maybe 2-6200s with the 7095, speed adjusted down abit, surely I could get a good 'back and forth' motion with these monsters.

Thanks again.

 

[samsfishnchips]

dude,

just wait a bit, roger is working on it,

I have seem the 110g with 2 6000s and it was sweet current with the 7094 controller,

man 2-6200 would be too much, but roger will surely give you the best advice,

sam

 

[Saldarya]

I agree that the 6200 full blown would be to much. But again, the cost is only $200 more for a set, and there is always that inevitable big tank upgrade in the next 18 months or so.

 

[rvitko]

I think you will have trouble with the 6200's that tank is just too small, even the 6100's would be a lot. I would go with 2 6000's. I have received a few invoices and things are getting back to normal and over the rest of February I can say for sure I am getting 60 6000 and 50 6100 and 50 7095 as well as 150 of each mag holder. I think we will start to close the gap on the backorder list, I am sure their will still be a wait but not as bad.