Tunze 3155 Error

[Swimwiththefish]

Just tried to turn on my tunze. I have it hooked up to my APEX, when power it on. I get an audio alarm along with the following LEDs

Red LED flashing on "too high"
Red LED flashing on "too low"
Amber LED flashing on "Pump On"
Green LED blinking on "Level"

Please let me know

 

[rvitko]

Normally if all 4 lights flash and beep in a repeated cycle the power supply is too weak or the pump is using too much power, try disconnecting the pump and see if it then starts normally and stays on, if so the pump is the culprit.

 

[rvitko]

BTW, it should do what you describe once on start up, then show a status light, run the pump 15 seconds and then start normal operation. This would happen every time it is switched on and for that reason is best used entirely stand alone.

 

[Swimwiththefish]

Normally if all 4 lights flash and beep in a repeated cycle the power supply is too weak or the pump is using too much power, try disconnecting the pump and see if it then starts normally and stays on, if so the pump is the culprit.

I disconnected the wires from the pump and turned it on. It still beeped. I then took the older power cord from and tried that still made the beeping.

 

[rvitko]

Is it repeatedly beeping or just once, it should always beep once when powered up and flash all four lights, if it does this over and over it has to be the pump or power supply, maybe the voltage out of the Apex is low so try no Apex and be sure you did not confuse the Apex and Osmo power supplies, they look identical almost but one is much weaker (Apex).

 

[Swimwiththefish]

Is it repeatedly beeping or just once, it should always beep once when powered up and flash all four lights, if it does this over and over it has to be the pump or power supply, maybe the voltage out of the Apex is low so try no Apex and be sure you did not confuse the Apex and Osmo power supplies, they look identical almost but one is much weaker (Apex).

It is continuously beeping. and i did plug directly into a powerstrip vs the APEX, same issues.

Send me a PM and maybe we can chat on the phone.