Tunze 6105

[Roy G. Biv]

Can you tell me the correct part number(s) for a magnet and clamp set for this pump? Right now it is hanging on a rail and I wanted to eliminate that.

I think it might be:

6105.515 2pc magnet
6065.650 silence clamp

but I'm not sure.

Thanks!

 

[rvitko]

Yes, that is the correct parts list.

 

[Roy G. Biv]

Thanks!

 

[WolfInRed]

Hi Roger,

One of my 6105 is acting flakey. Actually it not really working any more. It started acting flakey a while ago. I cleaned it all good and it just won't go. I exchanged power supplies and propeller assemblies that both work in the other 6105. It will give a little wiggle sometimes when I plug it in after I reset the propeller. Any thoughts. I suspect it needs to be replaced. Does it make sense to send it in for repair. I bought them 2/2011.

Best regards.
Erik

 

[rvitko]

Erik,

I can almost always repair them for less than replacement, in this case it sounds like the power supply is OK, you would likely need at worst a drive unit and motor, $132.04 is the cost of such a repair, it could be less than that. Send it in-

Tunze USA
305 Victor St
Austin, TX 78753