Tunze for a 75 sps

[cellexjohn]

What do you recommend for my 75 gallon sps tank(48"x18"X20"). I was looking at the TS-24 kit but after reading some of the info here, it would seem that would be way too much current in this size tank. Is it possible to run the 6100's at less then max and use this setup or should I just drop down in size. I want the 7094 controller compatable with my purchase.

Also, I read about the mounting brackets. I have a glass aquarium with a plastic rim. What exactly do I need to get with these to make this a smooth experience.

Thank you for your time in helping me with my decision.

John

 

[rvitko]

I would start with one 6000 Stream and if you want the multicontroller that is fine but I don't think you will need more than one. You will need kit 3000.244 for the pump to install on trim.

 

[cellexjohn]

Thank you for your quick response.

My next question, what exactly does the controller provided with this let you adjust? Can you adjust the rpm for a wave type motion, or just the desired speed setting? Is there some type of manual I can download so I can see what the settings are?

Thanks again
John

 

[cellexjohn]

Ok, Ijust found the 7091.000 single controller. I guess this would be needed also for the wave simulation(varying current). I fugure the one with the 6000 must just be a "speed controller" I cant quite make out the settings on front of the 7091. I guess some sort of operation manual could answer most of my questions.

Thans again rvitko
John

 

[rvitko]

John, pm me your email and I can send you the manual and what you could do is start with one pump and then decide what controller yopu want. If you decide on getting a second pump the multi is preferred. On the pump cable there is a computer called the driver- this gives you speed control. When the controller is attached the driver setting must be at full power. On a controller you will program two speeds and an interval and the pump will switch between these two speeds at 1-7 second intervals. It also gives you a 5 minute food break button and a night mode option.

 

[cellexjohn]

Thanks for the manual on the controllers. That helped alot. I placed an order for a 6000, and a 7901 along with the sensor, and the bracket kit.

Thanks again
John