Tunze Osmolator and Elos Mini

[todd03blown]

I just bought the Tunze and have the Elos mini, I assumed there is not issues using the ATO in the sump of this?

I looks like I will have to silicone the rails inside the sump wall since my water levels are lower since the sump is smaller.

Thoughts?

 

[rvitko]

I am not familiar with the Mini, do you have any photos?

 

[todd03blown]

Here are some pictures of my sump from the thread.

http://www.reefcentral.com/forums/showthread.php?s=&threadid=1455491&perpage=&pagenumber=2

 

[todd03blown]

Can any one post pictures of your osmolator in your nano that has a sump? I am just curious if the best way to attach the sensors is using silicone to the side of the glass sump as this appears to be better then hanging them off the top of the sump. If I go the route of hanging them off the top of the sump their appear to be to short to get the sensors at the right level.

Thanks for any help or pictures that can be provided.

 

[rvitko]

You could either use silicon and the fiberglass plates as shown in the manual or you could use the clamp and attach two rails together and place the float above the optic sensor on the same rail. To attach two rails together you use the same fiberglass plate and two screws.