tunze osmolator

[nanotrigger]

i changed to a magnet holder and now when the water is TOO high the light goes RED immediately and beeps.

how can i stop the beeping? it never did this on the old setup even when i stopped the overflow and filled up the sump.

thanks.

 

[pmrogers]

This sounds like normal behavior to me, or at least it's consistent with the behavior of the 3 osmolators I use. Perhaps your upper switch wasn't working properly in your old setup? The only way I know to stop the beeping is to lower the water level or lift the switch out of the water.

 

[rvitko]

This is what is supposed to happen when the float goes up, you can turn off the alarm by changing a jumper inside the controller, this is covered in the manual. My guess is that in your previous install the float was much higher up or was stuck.