Turbelle Stream Configuration

[bastoon]

Hi
I need help help for my tank configuration for my turbelle
tank : 1.80m x 1.00m x 0.65m (heigh)
I got 4 turbelles stream 6080 + multi controller 7094
For the surface I have 2 others pumps

How to install this to have the best configuration ?
thx for your help

Seb

 

[chaffey]

I thought the 6080 is not controlable, only 6000/6100/6200 and 6055 for nano steam.

 

[rvitko]

Yes, the 6080 is not controllable. Can you please explain your set up more?

 

[bastoon]

So in fact i got 4 Turbelles electronic 7400/2 that I modified to be like 6080.
It works fine but I would like to know the best configuration .. where to put the pump and which program to use.
thx

 

[rvitko]

The 7400/2 would convert to 6100's not 6080s. The 6080 runs synchornously on mains voltage and cannot be controlled. I would place them about 20cm under water and run them in Interval mode with 2 running at a time, place 2 on each side about 20cm in from the ends aimed straight across the tank.

 

[hahnmeister]

Id be looking at dual 6200s on that tank... maybe 3. Then again, Im running a 6100 in a 40B... so my tastes are a bit on the high-end for flow. My fish spend their days stuck to the pump intake.

 

[bastoon]

Hi

You are right....my powerhead has been modified like 6100.
I decided to only modified 3 powerhead into stream 6100 and to keep 1 powerhead for the surface all controlled by the multicontroller 7094.

So if I am not wrong my tank is about 245 Gallons and the total flow rate is about 7500 Gal/h

I put 2 stream on the same side and at the opposite I put my stream and my powerhead.
The opposite stream is oriented between the 2 opposite and the powerhead where the surface is not enough mix.