Used pair of 6060s.

SHOmuchFUN

New member
I just picked up a pair of 6060s in the selling forum.
I have a couple questions:

Apparently, they don't come with any mounting hardware. If I were to buy the magnet holders for these, would I need to make sure I purchase anything else with them to be sure they can be mounted to the magnets, if so, where would I find it? Or do the magnet holders come with all necessary hardware to mount the 6060s?

Also, I am planning on upgrading to a 120. Will these provide adequate flow in addition to a return pump from the sump? I plan to run at least 800gph as a return pump (~1100gph pump @ ~4ft of head). I keep primarily SPS, but also have a large carpet anemone and a couple BTAs.

Lastly, I have a Digital Aquatics reefkeeper and even though I would love to run these on a cycle, I have read that it voids warranty, burns the motor, etc... But did read that I could put them on a 1hr cycle. Would running these pumps at 1hr intervals on opposite cycles be beneficial? IE, one pump runs while the other is off, and after 1 hr, they switch.

Thanks for your help Roger. I appreciate it!!! I am excited, I may have to run one 6060 in the 55 SPS tank I have until I can afford to upgrade to the 120! :D
 
A 1hr interval would be fine, on the 120 with 2 6060's, I would probably overlap the intervals to create a storm like surge. You will need to have the swivel arm 6080.40 and the Sliding piece with Hinge part 6080.23 to use the magnet holders. In good news all the magnet holders will be probably in stock by the end of next week.
 
Do those pieces come with the magnet holders, or something I'd need to buy seperately? If I have to buy seperately, where would I get them?
 
You need to buy them seperately, they should have come with the pumps. They cost about $9 a set. Any of our dealers can order them for you, I also sell direct on spare parts.
 
Back
Top