What is the part to tighten the pump from moving?

[Infinitereef]

Have seen a thread before on this that someone suggest using a screw to tighten it? Where can I get the screw?

 

[rvitko]

You would just get a nylon screw and nut at any hardware store. The 6200 has a special threaded 6200.23 instead of the 6080.23 and this uses a 8mm screw.

 

[Infinitereef]

I have the 6100, so the 8mm nylon screw will work?

 

[rvitko]

No, not unless you thread the hole in the 6080.23 with an 8mm tap. As a do it yourself solution must people seem to be using a standard nylon screw that will fit through the hole and using either a wingnut or a nylon washer and nut to hold everything together. 6mm will fit through but I am not sure what standard size, most likely 3/16"

 

[mike660r]

I figured out a handy way to get mine to hold on tight. I used one of the long plastic screws with thumb knurls, two of the three holed flat plastic pieces and a nut from an extra mounting kit 3000.260 that I had. I ran the long screw down through on of the three holed flat pieces then into the stream mounting bracket down through the magnetic holder attatchment bracket and capped that off with another flat three hole flat piece and a nut. They are mounted very solid now.