atvdave
Premium Member
Hi Roger.
I upgraded my tank size to a 125G (72x18x22) and i found out that I have a few dead spots in my tank. I was wanting to get a couple of the nano Tunze to kinda push some water around, and get a good soft flow over my corals.
Even though I have had my aquarium up and running for over 3 years I don't know much about the Tunze pumps.
I see that the modes have a high flow rate:
6025-660 Gal/Hr
6045-1189 Gal/Hr
6055-1453 Gal/Hr.
I really don't want to blow my corals, and sand all over the place and that seams like a lot of flow, so my question is does it just kinda blow a wide pattern and not blow a narrow stream right at where it's pointed?
Also would the 6055 model be to much for a 125? I kinda want to put it on a timer or controller to make a somewhat wave action. Is this possible?
Thanks
Dave
I upgraded my tank size to a 125G (72x18x22) and i found out that I have a few dead spots in my tank. I was wanting to get a couple of the nano Tunze to kinda push some water around, and get a good soft flow over my corals.
Even though I have had my aquarium up and running for over 3 years I don't know much about the Tunze pumps.
I see that the modes have a high flow rate:
6025-660 Gal/Hr
6045-1189 Gal/Hr
6055-1453 Gal/Hr.
I really don't want to blow my corals, and sand all over the place and that seams like a lot of flow, so my question is does it just kinda blow a wide pattern and not blow a narrow stream right at where it's pointed?
Also would the 6055 model be to much for a 125? I kinda want to put it on a timer or controller to make a somewhat wave action. Is this possible?
Thanks
Dave