ocd_mariner
New member
So, dumping some water into the tank this morning, I managed to knock my WWD into the water bucket. It now shows a nice red color. Anything that can be done? The vortech was bought almost two months ago. =(
WWD kerplunk
- Thread starter ocd_mariner
- Start date
EcoTech Marine
.Registered Member
Hi Chuck,
Contact us at service@ecotechmarine.com, we'll try to salvage it if possible, but usually water damaged drivers are total losses. I'm more worried about the corrosion on the motor's terminals though, because it would be even worse if we had to replace that. After you disconnect the motor from the driver, inspect the motor terminals and if you see evidence that they got wet too, dip the connector in freshwater and allow it to dry out thoroughly to prevent salt corrosion.
-Tim
Contact us at service@ecotechmarine.com, we'll try to salvage it if possible, but usually water damaged drivers are total losses. I'm more worried about the corrosion on the motor's terminals though, because it would be even worse if we had to replace that. After you disconnect the motor from the driver, inspect the motor terminals and if you see evidence that they got wet too, dip the connector in freshwater and allow it to dry out thoroughly to prevent salt corrosion.
-Tim
ocd_mariner
New member
Crap.
Similar threads
