Ok, status on the hood.
The bulbs with the end caps measures 35". So i looking at the follow design.
Open Box/Frame
- 3"deep to protect the lamps
- Bulbs will be 5" on center
- Inside Box size will be approx 63"x18" (LxW)
Electrical
- The cables provided are 6 feet long.
- I'll have to extend with 18G solid wire
- bulbs front to back 1,2,3,4. One Ballast will light 1&3 the other 2&4, If we should do inside (2&3) ouside (1&4) let me know.
Mounting Ballast/Timer
- One on each side or both on the same side?
- Will be mounted on the wall
Any suggestions let me know. I cut the plywood into 3" width and ready for the fine cut/assemble
For paint was going to use some stuff I had around the house as it will not be seen.
Paul