MAXreefer
New member
I have been using the 2 sensors option on my Profilux II.
So far I used the "ATO with 2 sensors" for my ATO but I want to split up the functions. I would like to use only the bottom sensor for the ATO and the Top one to activate an outlet at the Powerbar.
Reason: Recently my return pump failed and having my heaters in the sump the water in the frag tank itself cooled off to much. Therefore I would like to put an additional heater in the frag tank itself and plug it in into the powerbar. The outlet should get activated when the top float switch gets activated due to the water level raising in the sump when the return pump fails.
My question:
What do I have to set in the "level" option to use one switch for ATO and how do I program the 2nd sensor to activate the outlet?
Thanks for any help
Michael
So far I used the "ATO with 2 sensors" for my ATO but I want to split up the functions. I would like to use only the bottom sensor for the ATO and the Top one to activate an outlet at the Powerbar.
Reason: Recently my return pump failed and having my heaters in the sump the water in the frag tank itself cooled off to much. Therefore I would like to put an additional heater in the frag tank itself and plug it in into the powerbar. The outlet should get activated when the top float switch gets activated due to the water level raising in the sump when the return pump fails.
My question:
What do I have to set in the "level" option to use one switch for ATO and how do I program the 2nd sensor to activate the outlet?
Thanks for any help
Michael
