6055 power supply

[pecan2phat]

Can someone tell me what voltage setting a 6055 should be on. The power supply has a slide lever from 12v-15v-18v-20v-22v-24v
Is this like the min/max screw adjustment on the old 6100 drivers?

 

[pecan2phat]

So after changing the setting from 18v to 24v, I blew out my 7095 controller....nice (powered off before changing voltage as per instructions on power supply)
I also see that without the blown controller hooked up, the voltage setting is for the max speed of the pump.
Now I either need to get a newer 7096 controller or the Aqua Surf since I have an AC3 but I had the Aqua Surf years ago when they were intro'd at Macna and didn't like it too much. Always needed to be unplugged and reset for some reason.

 

[rvitko]

You can use any voltage and it should not affect the controller. My guess would be the controller problem is a coincidence and not related. The transformer voltage sets the speed range, but in all cases the controller gets an 8V signal. I would send in the controller.

 

[pecan2phat]

Rodger,
Is it cost efficient for repair when a new 7096 is $158?

 

[rvitko]

Is it less than 2 years old? It may be under warranty if so. It may also be just a bad cable or connection. I have never seen one die like this so I would be curious to see what is wrong?

 

[pecan2phat]

It's more then 2 years old.
If I send it back for repair and it cost more then a 7096, will and can you give me the option to just replace with a 7096?

Thanks,
Warren

 

[rvitko]

Yes, be sure to include a phone number and return address and a print of these posts.

Tunze USA
305 Victor St
Austin, TX 78753